To enable us to identify the correct product for your requirements please complete the below form.
Required field
Required field
CUSTOMER INFO
  • Required field
  • Required field
  • Required field
  • Required field
  • Required field
  • Required field
GENERAL INFO OF THE APPLICATION
Environment:(tick one choice)

Field of application:
Required field

Type of drive:
Required field

Description of the drive:
Required field
PRELIMINARY INFORMATION
Do you want to replace a mechanical variator with a Smartdrive?

Do you want to replace a frequency inverter with a Smartdrive?
If YES:


Do you want to replace an inverter motor of the competition with a Smartdrive?
If YES:


Is there a mechanical reducer assembled to the Smartdrive?
ENVIRONMENT CONDITIONS

Humidity:

Corrosive materials:

Volatile dust:

Vibration:
GENERAL INFORMATION ON THE PLANT
Is it present an automatic differential switch?

Is it present an automatic magneto-thermal switch?

Is it present a network filter?

Are there other inverters supplied from the same plant?

Which is the maximum expected length of the electric cable that supply the motoinverter?
Required field

POWER SUPPLY NETWORK OF THE INSTALLATION COUNTRY

Max possible voltage in the 24h:

Min possible voltage in the 24h:

Frequency:
TYPE OF CONTROL OF THE INVERTER
Manual, by an operator:

Industrial PC:

PLC:

CNC:

Other inverter:

Other device:
APPLICATION INFO
AMax speed required at the motor shaft (nmax)
min-1

AMin speed required at the motor shaft (nmin)
min-1

APower required at max speed (Pb)
kW

APower required at min speed (Pa)
kW

BStarting torque required at the motor shaft (Ms)
Nm

CMin time of acceleration (Tavv)
sec

CMin time of deceleration (Tarr)
sec

Type of duty of the motor (tick one choice):

(1) The motor performs a S1 service if, once started, it remains in movement without any stops.

(2) The motor performs a S2 service if, once started, it remains in movement for a limited time (20-30 minutes) before a stop of 2-3 hours.

(3) The motor performs a S3 service if it is subject to iterative cycles of starts and stops for a short time (maximum 2-3 minutes).


In case of limited duration duty (S2), how long is the movement?
Min

In case of intermittent duty (S3, S4, ...), how long is the movement phase?
sec

In case of intermittent duty (S3, S4, ...), how long is the stop phase?
sec

In case of intermittent duty (S3, S4, ...), which is the duty cycle?
sec
MAGNITUDE TO REGULATE AT THE MOTOR SHAFT
Speed:

Torque:

Position:
PRECISION REQUESTED FOR THE VARIATION
Speed tolerance
%

Torque tolerance
%

Position tolerance
%
MODE TO SELECT THE SPEED
Potentiometer on board:
Analog voltage signal +/- 10V

Remote potentiometer:
Analog current signal 4-20mA

Keyboard on board:
Binary combination of digital inputs

Remote Keyboard:
Square waveform with frequency modulation

Analog voltage signal 0-10V
Serial RS485 Modbus

Analog current signal 0-20mA
Fieldbus
INVERTER FUNCTIONS
Start/Stop:

Change the direction of rotation:

Speed reference:

Other:
INFORMATION ON THE INVERTER
Alarm signal:
Reached reference:

Motor Status:
Working frequency:

Other:
FIELDBUS
Serial RS485 Modbus RTU:
Owner CANbus:

Others:
TOOLS FOR PROGRAMMING THE INVERTER
Keyboard on board:
Serial RS485 Modbus:

Remote Keyboard:
Fieldbus:

Other:
OTHER REQUIREMENTS OF THE MOTOINVERTER
Protection degree IP: